Southern Components, Inc.

Lowest Installed Cost!!!

Our technical department concentrates on giving you the lowest installed cost, which is true to the cost of the job. Your lowest cost is not necessarily the lowest bid. Our technical department works to keep your overall costs down by focusing on the following:

Spotting Design problems and situations that will not work before they reach the field.
Consultation with project architects and/or engineers to solve problems discovered with plans during the bid process.
Designing for the most cost-effective installation process by simplifying areas that may cause installation problems for the framer where possible.
Reducing material needed on jobsite for permanent bracing with designs requiring less lateral bracing.
Fast turn-around of shop drawings due to our extensive front end work done during the bid process.
Consultation services available with both the contractor and the framer to assure concerns are addressed prior to fabrication when needed.
All fabricated products are clearly and precisely marked for proper identification in the field and to match furnished shop drawings.
State-of-the-art equipment used in the fabrication of supplied components for accurate fit to members, tight joints and properly embedded connectors.
Constant in plant inspection for compliance with project engineering designs and project requirements.
Accurate Roof and Ceiling Planes. Precision jigging and set-up, computerized cutting equipment, trained workforce, quality inspectors, means less field problems.
Quality Certified! We pay inspectors (SPIB) to inspect our inspectors to insure you receive what you pay for and to reduce your risk of call backs and future liability problems as a result of poor quality.
Proven Track Record. 45 years of continuous operation with a dedicated, industry knowledgeable and stable work force ensures you top quality and service and the most reliable products in the industry.
State-of-the-art design and engineering software to ensure accurate roof plane and ceiling plane input. This helps with spotting problems that were missed during the design phase of the project.
All truss designers are WTCA TTT training certified and receive continuing education to improve the reliability of our products.
Should problems occur. Our in-house technicians are available for consultation to remedy any problems in a short time frame.